![]() ![]() Program Unlimited Key Code (vehicles without push-button start only) Unlimited Key Mode ON/OFF (vehicles without push-button start only) Disabling the Unlimited Key Mode restores the RKE function without the need to erase and reprogram keys. Enabling the Unlimited Key Mode disables the RKE function until an Erase and Program Keys function is carried out. The RKE function only operates for the first 2 keys programmed when the Unlimited Key Mode is enabled. NOTE: Unlimited Key Mode should only be used to program more than 8 keys for fleet vehicle purposes. NOTE: Common anti-theft security access choices are:Ĭustomer Spare Key Programming Enable/Disable NOTE: When programming keys, the RKE transmitter and the PATS portion of the key are programmed at the same time. A hardwired connection is strongly recommended. NOTE: In order to gain module security access, the diagnostic scan tool must have an active Internet connection. You should be able to get into pats security and preform a perimeter reset we can in the USA.Īnti-Theft Security Access and Key Programming - Scan Tool Where did you get your subscription from?īelow is the ford keyless programing chart. Tell me how you make out.ĭo you have genuine Ford IDS with a non dealer subscription and not a Chinese VCM clone? Missing key code and keys not programed code can be as easy as putting one key in the ignition and turn on for 3 seconds and off remove key and insert second key and turn on for at least 3 seconds and off then try to start car. If it don't and the PATS has lost the keys you will get B10D7:51 keys not programed, B10D7:55 PATS Key: Not Configured or B10D7:87 PATS Key: Missing Message. When done exit out, clear and retest for codes and P161a-b should be gone and try and start if it starts great. Check the tick.Follow the screen and enter security access mode and wait the ten minutes and click on the tick. In IDS you click on toolbox, then body then security then pats functions. That vehicle should have the pats in the BCM. The manual steps is to enter pats security mode and preform a pats parameter reset. Both code are "Incorrect Response From Secondary Immobilizer Module" You have to perform a pats parameter reset. ![]()
0 Comments
Leave a Reply. |